Re-flashing bios on dead aladdin x2 Plus2.
Im not sure what went wrong but i tried to update the aladdin x2 Plus2 to the ind 5003 via Xblast ( loaded oh hdd )
The flash appears to be successful but after a reboot i got the 3 boots and frag. Now it appears the chip is dead.?
Thankfully i had another X2 Plus 2 and using that i can boot again
I thought maybe i could hot-swap the chip and re-flash the bad one. However when i pull the chip the console appears to freeze and video goes to black.
Im running off a Hexe 0.99b11-22 heimdalls xbox engineerind disc to try and re-flash
1.6 pal xbox
Any ideas if this is possible?
I upgraded my xbox to a 1TB sata drive but I can only see 123gb. I understand I need to update the bios on the modchip I have which I believe is an Xecuter 2.3 lite.
I tried using Hexen to upgrade to x2.4981 but I get the message !!Flash Not Writeable!!
This happens if I have the switch set to protect or unprotect, Bank 1 or Bank 2.
I downloaded a copy of x2.5035 so I could go with that version outside of Hexen, but I don't know how to do that.
Please could someone assist me. Thank you.
Hello everyone. I have a question. Can i use only F partition on a 67 Bios? I am asking this because i am using ind-5004 bios and it was fine as far as i had F and G. Recently i decided to make just 1 F partition. I loaded xbpartitioner 1.1 and create a single 290 GB partition for F(it was 120 F and 170 G before) and after that i started loading stuff in it. The problem is that after the free space went to 32-35 GB(dont remember excactly)no new files would be writen on the F partition. The other partitions would get files normally. If i delete something on the F,then it would accept files again until it reaches the free space limit.... Am i doing anything wrong or is the bios supposed to work only with G too?