Jump to content
dertio

Help I Make a Upsie

Recommended Posts

Hi people, welp I make a upsie in my Xbox trying run pgr2, first try copy several times the game over ftp but noting works so I think well maybe is the installation of dashboard so I put another installer in my x, I guess is evox someting, was a old dvd from 2010 or 2008 based on evolutionx dash and green radioactive backgroun, anyway the trouble is, boot to original dashboard but can't boot from DVD coz I flash the DVD check disable bios so cant make a cold boot from hexen dvd to try reflash the custom dash also can't boot from original game still saying the disk is not a original one, ohhh almost forgotten say my version, is a 1.6 board with aladdin xt2 plus, evox m8 firmware with dvd check disable, I guess I need make the hot swap between my pc and the Xbox hdd, ohhh alsothis console came with a bigger hdd When I bought it but that hdd is dead (head crash 😭 ) so I put another "working" IDE drive I had laying arround the house and say working coz this disk had some bad sectors is not like 1000 bad sector just 3 sectors and works fine until I made the stupid think but that's not the point, so my question is any possibility to recovery the dash without pc xbox hdd swap, is not a problem do that I had a old desktop pc with IDE interface but I can't find my cd with linux s.o and all the stuff for softmod I burn years ago (2006 or 2007 and still working that cd) or There is a better way to flash a custom dash and boot the hexen disk

Edited by dertio

Share this post


Link to post
Share on other sites

If your hdd is unlocked you can fix your hdd using Xboxhdm or fatxplorer, you should have an evoxdash.xbe in your C partition which will either be your dash or a shortcut to your dash on your E partition.

Share this post


Link to post
Share on other sites

Well i make the situation worse, I don't remember when but I locked the HDD so I need use hot swap method, and luckily I found my cd with xboxhdm idk what version is but boots and works so I'm using that, now that cd don't want make a partition in the HDD I can format with option 5 format fatx table partition but I can't redo then and e partitions

 

So thinking about I had a 120gb sata hdd and usb converter so the idea is make akother hdd and use the cloning option in the xboxhdm with all the stuff installed ready to go, so I download the vertion 2.3 beta and the .zip from reddit....

Share this post


Link to post
Share on other sites
22 hours ago, dertio said:

nyway the trouble is, boot to original dashboard but can't boot from DVD coz I flash the DVD check disable bios so cant make a cold boot from hexen dvd to try reflash the custom dash also can't boot from original game still saying the disk is not a original one

The BIOS's DVD check disabled option doesn't prevent the Xbox from booting a DVD when you power on the console.  It is used to disable the BIOS's check to make sure that an Xbox DVD drive is connected to the IDE and DVD power/control cable of the Xbox.

Share this post


Link to post
Share on other sites
5 minutes ago, KaosEngineer said:

The BIOS's DVD check disabled option doesn't prevent the Xbox from booting a DVD when you power on the console.  It is used to disable the BIOS's check to make sure that an Xbox DVD drive is connected to the IDE and DVD power/control cable of the Xbox.

Okay but that not explain why refuses to boot from the dvd, but the dvd drive is working fine Despite being old....

That's not matter now, the HDD is formated and the Xbox display error 14 or was 21, something related with the hdd, today in the afternoon I going to try the cloning option in the xboxhdm I had burned, may be a good chance to revive my console with this

Meanwhile, I found a screenshot from the auto installer I try yesterday, was the slayer's evox auto installer v2.6 and still unknown why fail to install the custom dash 🤔🤔🤔

Share this post


Link to post
Share on other sites
4 hours ago, dertio said:

Well i make the situation worse, I don't remember when but I locked the HDD so I need use hot swap method, and luckily I found my cd with xboxhdm idk what version is but boots and works so I'm using that, now that cd don't want make a partition in the HDD I can format with option 5 format fatx table partition but I can't redo then and e partitions

 

So thinking about I had a 120gb sata hdd and usb converter so the idea is make akother hdd and use the cloning option in the xboxhdm with all the stuff installed ready to go, so I download the vertion 2.3 beta and the .zip from reddit....

Ufff I wire this awfully

 

Well fixing what I want say in that post:

I download the xboxhdm 2.3 beta for usb so the idea is make a second hdd with my laptop installing all the stuff and partitions in it, them conect to the sata port in the hot swap pc and do the cloning hdd stuff with the "hack the Xbox cd"

Share this post


Link to post
Share on other sites

Okay my x is alive again, how I managed restore the hd, well using the xboxhdm usb 2.2 slax with all the stuff I need in a small sata hdd, so I boot from there and then i did all stuff for a new hdd also install the dash, I dunno why But the x was refused to boot and sitting on error 21, them with the HDD unlocked I boot windows 7 and navigate via x360 manager, open the HDD, and copy all the stuff from the cd I had (the same utility but old maybe is 1.7 or something) the think is I remember that cd was ready to go with unleash dashboard, anyway I copy the c folder to my hdd and them boot from the Xbox, and wala is alive, the next think I did was flash the tsop without the noDVD in case I made another stupid think and reinstall the hexen dashboard

Edited by dertio

Share this post


Link to post
Share on other sites
On 9/3/2020 at 9:30 PM, KaosEngineer said:

The BIOS's DVD check disabled option doesn't prevent the Xbox from booting a DVD when you power on the console.  It is used to disable the BIOS's check to make sure that an Xbox DVD drive is connected to the IDE and DVD power/control cable of the Xbox.

Unless the EvoxM8plus.bin BIOS comes from the 2020 Hexen disk it locks out the DVD full stop.

 

 


Cheers

SS Dave


Soft modding is like masturbating, It gets the job done but it's nothing like the real thing.

 

Share this post


Link to post
Share on other sites
1 hour ago, SS_Dave said:

Unless the EvoxM8plus.bin BIOS comes from the 2020 Hexen disk it locks out the DVD full stop.

 

 


Cheers

SS Dave


Soft modding is like masturbating, It gets the job done but it's nothing like the real thing.

 

Yup was that bios, that's whI couldn't "flash" again the dashboard

Share this post


Link to post
Share on other sites

Hexen strikes again.

Can you FTP to the Xbox?

 


Cheers

SS Dave


Soft modding is like masturbating, It gets the job done but it's nothing like the real thing.

Share this post


Link to post
Share on other sites
10 hours ago, SS_Dave said:

Hexen strikes again.

Can you FTP to the Xbox?

 


Cheers

SS Dave


Soft modding is like masturbating, It gets the job done but it's nothing like the real thing.

Right now yes coz it is repaired, I fixed my console with xboxhdm2.2 usb and my old lga775 with IDE port, via hot swap method, with that I can create all the partitions and stuff needed, and the last stuff I need do was copy the dashboard to c via xplorer 360 in windows 7 and that's it, the last thing I do is flash the bios without the noDVD

 

 

Share this post


Link to post
Share on other sites

If you download this and extract the files then FTP it to the Xbox

Please login or register to see this link.

then use file explorer to find and then run the default.xbe.

You can then reflash the BIOS with the ":evox_m8+67-NO-DVD.bin" and your DVD with start working again.

Yes this BIOS works 100%.

 

 


Cheers

SS Dave


Soft modding is like masturbating, It gets the job done but it's nothing like the real thing.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Content

    • By Wingman
      Hello everyone, my name is Vitalij and I am from latvia ! 
      I have two xbox v1.1 and v1.6  in 1.1 dump of something (red-green light), but fully working power supply and 1.6 working, but the mosfet burned out in the power supply.
      Is it possible to make a 1.1 to 1.6 PSU, can there be a complete manual or something? I found a guide showing how to make from 1.1 to 1.2-1.5, but as I understand it, this does not work for me.
      Could you please help with this?
      Please login or register to see this code. Please login or register to see this attachment.
      Please login or register to see this attachment.
      Please login or register to see this attachment.
      Please login or register to see this attachment.
    • By sh0rtlife
      everything's been solid for some time now save for a couple of games that simply refuse to work and im ignoring them....., so my wife created a new profile to use instead of using mine so she could set faves and such...seemed like a good idea....but now, no profile works...so im stumped
      "script error"script failed xbmc4gamers"
      then it pops up a message on the bottom left of the screen
      "error script is missing or taking to long to finish, please send me a copy of your xbmc.log file "
       
      i assume the log file thats needed is the /E/xbmc/system..if so..its attached.
      Please login or register to see this attachment.
    • By Ravenhunter85
      Hello All,
      I have a xbox that i picked up used, and it has a xecuter pro 2.1 (i believe) but it does not have the front or rear rs232 or DIP switch plates. When i boot i get an error of an unlocked drive, so I assume it is trying to boot to factory BIOS and it has a WD 120GB IDE drive in it. I tried to jump the D0 wire to ground as I read that would force it to use the xecuter's bios, and when I do that I get a greyscale screen that "xbox Linux Clean BIOS 1.22dev" screen that tells me to put in a disc. is this something i can do with Hexen? Thank you for any help

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.