Leaderboard

Dear All, As you know, the stock fan of original Xbox is quite loud, and given the age about 15 to 16 years I decided to upgrade/replace the fan, read some forums and some suggest the Nexus 70mm Real Silence fan, which has an airflow of 21.1 CFM, but since I'm from Europe this fan is not available almost in no place, owing probably to being an older fan design, looked for alternatives, and some suggested a Noctua 80mm which we need to butch the HDD plastic bay to fit on the box, but there's also a 60mm model, which fits excellently which is NF-A6x25 FLX. that address an airflow of 29,2 CFM which is better than the first solution Nexus 70 mm. Alright connected the fan with the 4 anti vibration rubbers and this is the final result. Still haven't replace the thermal paste, that's going to be my next project, really now I have a quiet XBOX on my hands

Some skins I came across on a box when repairing. Thought I would share as these are not on the Slayers Auto Installer Skin.rar Just FYI there seem to be alot of adult skins

got my controller, just have to reflash a SD card for my pitaya and test to make sure the controller works then I can start reading the buttons.

Great to hear! You are correct, not many pins are required for the slave modules. These are the bare minimum for player 3 and 4 (looking from the top). I tried to do the corners as well to give it a bit of extra strength.

So I cut the player 1-2 wires that go into the ports, and soldered them into the Micro USB plugs (same ones you used), and installed your board under the DVD Drive.,

Thank you Razee119! Fantastic product!

For anyone trying to sign up for the fourms and it was not working before i have resolved the issue

Thanks KE, I did notice that my G seemed to be empty after cloning... something didn't quote go right but its all good. I planned on wiping F&G anyway. I just checked with XB Partitioner and the G partition had 1600+Gb so i have reformatted so F&G both have 927.78Gb now. Thanks for the help.