franci06 Posted September 1, 2022 Report Share Posted September 1, 2022 Hi everyone, i have a 1.3 xbox with OpenXenium that i recently installed, however when D0 is grounded via the modchip or the ground point the xbox frags and won't load the modchip. I checked everyting and the joints are ok and also the traces. The console works fine without the D0 grounded since loads the default bios. By checking with the multimeter while in frag i discovered that the pin 5 is 0.19v instead of 3.33v. The pin is 3.33v when the D0 is not grounded. Quote Link to comment Share on other sites More sharing options...
franci06 Posted September 5, 2022 Author Report Share Posted September 5, 2022 Ok, just found out the pin 5 is not the issue, still the console won't boot with the modchip Quote Link to comment Share on other sites More sharing options...
KaosEngineer Posted September 5, 2022 Report Share Posted September 5, 2022 If it FRAGs with D0 connected and grounded then most likely, even though you say they are good, there is something wrong with the connections of the modchip to the LPC debug port. Post pictures of the install. Especially the pin header solder joints on the bottom of the motherboard. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.