MarkC1970 Posted May 14 Report Share Posted May 14 I have just taken the heatsink of a v1.0, cleaned it up and replaced with MX4. It seem to work OK but the heat sink is not clamped to the CPU at all well. I can rotate it with no trouble and even rock it side to side. Were the original thermal pads adhesive? Were they 1mm thick and I need to now pack the clamp out? Any thoughts? Thanks. 1 Quote Link to comment Share on other sites More sharing options...
Donnie-Burger Posted May 14 Report Share Posted May 14 1 hour ago, MarkC1970 said: I have just taken the heatsink of a v1.0, cleaned it up and replaced with MX4. It seem to work OK but the heat sink is not clamped to the CPU at all well. I can rotate it with no trouble and even rock it side to side. Were the original thermal pads adhesive? Were they 1mm thick and I need to now pack the clamp out? Any thoughts? Thanks. Gpu can slightly move when clamped. CPU should be pretty tight clamped down even with arctic mx 2/4. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.