My V1.1 Xbox is triple fragging, this happened after I tried swapping out the 40 Pin IDE cable for a 80Pin one.
I've done a bit of debugging and found that the LPC header pins 3 and 5 aren't reporting correct voltages both reading below 1v
What I think has happened is when I installed the 80 Pin IDE cable I without knowing freed up one of the solder joints on the switch that's on the XeniumICE which switches it into recovery mode(I have resoldered the broken joint and it didn't change anything and yes the switch is in the correct position, though I've tried both positions and still a frag) and somehow that's caused something to get fried but I'm not sure what exactly
Uploaded some pictures of my LPC header soldering and D0 point for shits and giggles I have done continuity tests to the alternate points and they're all reading with continuity
https://imgur.com/a/rBbAdlR
So I was looking back into Xbox emulation to see how it has progressed, and Xemu claims it can play 62% of the games library now. I was reading up on how it works and you can command line load an iso, but it doesn't support compressed isos so I'm not interested in that method. It does also support Xbox hard drive images however, and custom dashes. I'm curious if anyone has used xboxhdm to create a hard drive image with one of the hard drive ready rom sets out there and a custom dash to play them in Xemu? Xemu doesn't specifically piece this all together for you on the website, but it seems that should work. Either way I'm going to try it, but just didn't know if anyone knows.
Got this xbox with a couple of 360s and it puts the logo up and the Microsoft logo also pops up then nothing.
Put Halo2 disc in and it booted up and showed the previous players save games so i assume the HDD is working at least. Now i thought it had been modded as when i looked underneath it had warranty stickers over the labels you have to cut to open the machine. Also the modder/repairer and also put hot glue in the torx screws (twat).
Alas no hardware mod and i know next to nothing about softmods (my modding was always HW mods).
Also i got this nice message when i took the lid off.
Some suggestions would be appreciated as at the moment I'm thinking something may have happened to a softmod.
Recommended Posts
Similar Content
I've done a bit of debugging and found that the LPC header pins 3 and 5 aren't reporting correct voltages both reading below 1v
What I think has happened is when I installed the 80 Pin IDE cable I without knowing freed up one of the solder joints on the switch that's on the XeniumICE which switches it into recovery mode(I have resoldered the broken joint and it didn't change anything and yes the switch is in the correct position, though I've tried both positions and still a frag) and somehow that's caused something to get fried but I'm not sure what exactly
Uploaded some pictures of my LPC header soldering and D0 point for shits and giggles I have done continuity tests to the alternate points and they're all reading with continuity
https://imgur.com/a/rBbAdlR
Put Halo2 disc in and it booted up and showed the previous players save games so i assume the HDD is working at least. Now i thought it had been modded as when i looked underneath it had warranty stickers over the labels you have to cut to open the machine. Also the modder/repairer and also put hot glue in the torx screws (twat).
Alas no hardware mod and i know next to nothing about softmods (my modding was always HW mods).
Also i got this nice message when i took the lid off.
Some suggestions would be appreciated as at the moment I'm thinking something may have happened to a softmod.
Board Life Status
Board startup date: April 23, 2017 12:45:48