Hari125
-
Posts
44 -
Joined
-
Last visited
Content Type
Profiles
Forums
Calendar
Store
Everything posted by Hari125
-
Also one of the silver capacitors is looking really bad. I don't know is it going to fix the issue, but it definitely needs replacing. (Replacing both of them won't be bad idea) -
It's possible. But another possibility is broken capacitors near the cpu.
-
Opening the drive will be a bit slower than with original belt, BUT it will work.
-
Also i added a bit of metalic foil on the rubber. That way the A button is easier to press.
-
You saved my life. I rubed pencil on the conductive pad where the A and X button are sitting and pasted some thin tape to secure the graphite. After that i closed the controller to test it and it worked! The X started working normally as before and the A (that was dead) started working TOO, but it needs a lot of pressure to work. I'm really thankfull that at least is working. Maybe i will end up buying the chungus duke controller (i like it). Here is how turned out:
-
It's not 1.6 or 1.6B whitch cannot boot without it, so it's not worth the time and money.
-
Maybe there are some leaking capasitors. The leak that comes out of them is conductive and eats away metal (that eventually could cause short circuit). You should replace them with high quality ones and before that - clean the leakage with isopropyl alcohol. Hope that's helpful
-
Hi! I opened my xbox controller s to clean it with 95% alcohol and eventually cleaned the black part (where A,B,X,Y,black,white buttons are) with it. I didn't know it was touch digitizer ;-; After i assembled and tested it, the A and X buttons weren't working propertly. The X needed a lot of pressure to work and the A didn't worked at all. After 2 days the X button worked, but it still needs little pressure to work, but the A is like stone dead. Any suggestions? Are there any pins to short so i can simulate button push and eventually to add normal button to work as A.
-
Ok thanks.
-
I don't know how and is there any tool for the xbox, but you could connect the hdd to pc and check the health with hard disk sentinel. Hope that's helpful.
-
What are the white plugs numbered with 1,2,3 on the picture? Also you saved my life. Time for moding..
-
Do you know how much posts i should have?
-
Can't reboot Xbox trough button combination
Hari125 replied to moreno9's topic in General Xbox Discussion
I haven't heard of reboot button combination. I know comb. that will get you out of an app that you opened - LT, RT, back and black (you have to hold them at the same time, not one by one). -
sry wrong forum
-
This is really bad. I was going to recomment you to follow the traces that were connected to the caps, remove a bit of the green layer that covers them and then soldering wires that are soldered to the caps, but the board is multilayer and it wont be easy to repair. I'm sorry to say it, but you are doomed. ;-;
-
The voltage seems mostly fine to me. There are some power loses and it's possible to be broken capacitor/s (even if they arent leaking).
-
Board Life Status
Board startup date: April 23, 2017 12:45:48