Jump to content
OGXbox.com

[EU] WTB aladdin Xblast


Naokhan
 Share

Recommended Posts

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Similar Content

    • By alcatraz68
      For some reason while trying to flash a new bios to my TSOP I got a message saying 'programming failed', and now I get no picture when my console boots and the LED flashed red and green. So i'm thinking it's bricked. I was wondering if I installed a mod chip would this then save the console? I've seen an 'Aladdin XT+4032 X2 Plus' on eBay and the installation seems very simple for these chips.
    • By Incursion64
      Hello, hoping someone can help here.  I've made several xblast aladdin chips, as well as the Jafar chips, and quickboot will never boot the designated bios i have selected in Xblast Settings.  No matter what i do, it always boots to the Xblast OS.  For example: i have quickboot set to yes, i have X25035 as my 512k Bank(0), IND5003 as bank(1), and Cromwell as bank (2) aka Xblast.  If i assign either the 256k or the 512k bios to launch pressing the Eject button, it will work as it's supposed to.  
    • By MadMartigan
      I made a post a few weeks back about getting a 1.6 with a HDD that immediately died after booting. Couldn’t get eeprom in time. Looks like someone was trying to tinker around and really screwed some things up. Without the wires and chip, the Xbox will boot into HDD failure error which I’m fully aware of. I tried getting two Aladdin chips fitted and neither one of them will boot. They both flash green light for a second and then power off. One chip shows red light and the other shows yellow. I’ve reflowed solder points countless times and still the same result. I’ve tried D0 grounded to board and the chip and other various places I’ve seen and read about, but nothing works. As you can see from the board, there have been several trace lifts, but from what I’ve seen I have everything linked up properly accordingly to the lifted traces. Any help would be greatly appreciated. 
       
      I do not want to keep the chip inside so I have not cut the L-Frame. I just want to pull the eeprom and build a replacement drive. These Aladdin chips on 1.6 are proving to be a real pain in the ass. 


Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.