Help with HDD and LAN LEDs

[Bowlsnapper]

I just need to know how to wire these LEDs up and what the resistor values are. I can't find any place that is either still up or still hosting photos.

[SS_Dave]

The spots shown are negative switched (From memory)  and if the LED is running from 5 volt then a 220ohm series resistor should be fine.

 

Cheers

SS Dave

Soft modding is like masturbating, It gets the job done but it's nothing like the real thing.

[Bowlsnapper]

7 hours ago, SS_Dave said:

The spots shown are negative switched (From memory)  and if the LED is running from 5 volt then a 220ohm series resistor should be fine.

 

Cheers

SS Dave

Soft modding is like masturbating, It gets the job done but it's nothing like the real thing.

Forgive me for my noobiness, but in this context, what does negative switched mean? The lower boxes are just D0 for 1.0-1.4 mobos, correct? Ground for these leds is just regular ground? If I have 3.5V LEDs these HDD and LAN leads are 5v, which means 220ohms? I read 470 for the controller ports. I'm learning resistances. Sorry, I'm a bit of a dummy in this instance. 

 

Lol, the xecuter instructions. DUH. I'm an idiot. Why didn't I think of that?

Also, I would like to hook up the LEDs to molex sockets in case I want to remove the motherboard...

 

Edit: It's okay. I found some molexes that should work.

https://www.amazon.com/Letool-Electrical-Female-Connector-Cables/dp/B07FP2FCYC/ref=asc_df_B07FP2FCYC/?tag=hyprod-20&linkCode=df0&hvadid=459486453992&hvpos=&hvnetw=g&hvrand=4124367277349490832&hvpone=&hvptwo=&hvqmt=&hvdev=c&hvdvcmdl=&hvlocint=&hvlocphy=9031634&hvtargid=pla-930783811610&th=1