Jump to content

Search the Community

Showing results for tags '2.6'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Off Topic
    • New Member Introductions
    • Rumble Pit
    • Suggestion Box.
  • General Xbox Discussion
    • General Xbox Discussion
  • Original Xbox Modding Forum
    • Hardware Mods
    • Modchips
    • TSOP Flashing
    • Softmods
    • Repair
  • Xbox Case Modding
    • Case Mods
    • Lighting & Electrical Mods
  • Tutorials
    • Official Tutorials
    • Tutorial Submission
  • Software
    • Bios
    • Dashboards
    • Installation Disks
    • Applications
    • Games
    • Emulators
    • Homebrew
  • Xbox Collecting
    • Xbox Collection Showcase
  • Rare and Uncommon
    • Rare and Uncommon Xbox Hardware
    • Rare and Uncommon Xbox Software
  • Vendors
    • N64 Freak's Products
    • Barnito's Products
  • Development
    • Rocky5's Projects
  • Online Play
    • Game Night
  • Classifieds
    • Wanted
    • For Sale
  • Moderator Section
    • Moderator Back Room

Product Groups

  • Vendor Forum
  • Membership Subscriptions
  • Forum Ads

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


About Me

Found 2 results

  1. Hello, I am writing this today to see about getting some help with my 1.6 Xbox and the Xeceuter 2.6 CE installed in it. I recently did this motherboard mod involving a resistor to extend the life of the board and the board works fine after the install. This is also where I managed to find an issue. With the mod chip enabled, both banks load up their respective bioses, but when I disable the mod chip using the front panel switch, the console Frags after 3 tries. When I disconnect the LFrame wire from the mod chip, the console boots up like normal to the stock dash using the stock bios. Before the mod though, disabling the mod chip using the front panel switch worked liked normal. So now I am a point where I made a modification to extend the life of the console, but lost some functionality in my mod chip at the same time. I am wondering if anybody knows what would cause the issue I described and if anybody else has ever run into similar issues. Though I know most don't tend to mod 1.6 consoles if the can avoid it. I'm also curious if anybody else happens to have an Xbox motherboard that is warped around the CPU and GPU area. By warped, I mean that I can see a curve in the motherboard around that area. Thanks, DobaMuffin
  2. Xecuter 2.6 ce motherboard v1.6 and 80gb ide all wires and 1 official controller 100 usd shipped us only

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.