monblondero Posted August 18, 2018 Report Share Posted August 18, 2018 Hello,I have two xboxes, version 1.2 and 1.4 in both of them after the start Frag.They do not have a tsop. In one there was a chip for a spider web with cromwell, I soldered the chip and the console got Frag.In the second one, however, it worked but after replacing the past, it stopped competing.I tried to run both aladdin but it does not help,any ideas ? Quote Link to comment Share on other sites More sharing options...
big F Posted August 19, 2018 Report Share Posted August 19, 2018 What error code do they produce ? if you have the factory HD and can remove the chip from its header does it work with the standard drive installed. Quote Link to comment Share on other sites More sharing options...
monblondero Posted August 19, 2018 Author Report Share Posted August 19, 2018 (edited) Thanks for the answer The hard disk and drive is originalChip removed on both consoles, screen black so there is no obvious error. Edited August 19, 2018 by monblondero Quote Link to comment Share on other sites More sharing options...
KaosEngineer Posted August 19, 2018 Report Share Posted August 19, 2018 (edited) So you have 2 consoles 1.2 - no modchip installed - resets a couple times then flashes red/green with no video out. 1.4 - same Is the D0 point permanently grounded by soldering a wire from it to a ground point on the motherboard, no connection was made to modchip's D0 pad? -- KaosEngineer Edited August 19, 2018 by KaosEngineer Quote Link to comment Share on other sites More sharing options...
KaosEngineer Posted August 19, 2018 Report Share Posted August 19, 2018 22 hours ago, monblondero said: In the second one, however, it worked but after replacing the past, it stopped competing. Don't understand this statement. Some words must be the wrong: past and competing. Quote Link to comment Share on other sites More sharing options...
monblondero Posted August 21, 2018 Author Report Share Posted August 21, 2018 Whether with a chip or without consoles have a frag. There were no tsop mods.One at the beginning after the purchase had a frag, after the next switch-on, but at the next attempt again frag.The second one had the cromwell chip loaded, there was no dash, I removed the chip made on the spider web and the phage appeared. I suspect that the problem lies on the side of the tsop load?I installed the aladdin for the second console, but the console was not started by the black screen. Quote Link to comment Share on other sites More sharing options...
KaosEngineer Posted August 22, 2018 Report Share Posted August 22, 2018 (edited) If a system is softmodded and a modchip is installed the result is generally a black screen after startup. Fix: Remove the softmod files from the HDD by rebuilding the C drive with a clean MSDASH file set. Cromwell is a BIOS, not a Modchip Cromwell is a BIOS that can be flashed to most any modchip. To ID the modchip, you'd have to open the case up and take a look at it. Find a picture of a known modchip that matches or read the modchip name from the circuit board or component with such labeling. The Cromwell BIOS is not capable of loading a replacement dashboard. Its purpose is to boot Linux or reflash the modchip with a modified/hacked BIOS that can. FRAG with or without Modchip If a system FRAGs with the modchip enabled or disabled (which includes uninstalled) there's a problem with some major section of the console. Edited August 22, 2018 by KaosEngineer Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.