Jump to content
OGXbox.com

monblondero

Members
  • Posts

    13
  • Joined

  • Last visited

Everything posted by monblondero

  1. Hello, my xbox 1.6 crystal not signal in tv. What can you do ? cable ok, psu ok. capacitors ?
  2. Hello, I know that I should not upload the m7.bin bios to the xchanger, but what to do when it's uploaded and the console on it has no menu. Is xbox supposed to behave like that? And how to restore another bios in xchange is any recovery menu ??
  3. I wanted to fix the tsop, after a bad flash
  4. I do not have an xchanger menu, I do not know how to resuscitate him?
  5. I have an xchanger chip, I know that we are uploading the firmware over the network or from a cd / dvd disc. What should I do when I download the m7.bin file to the layout? There is a chance to resuscitate him. Because after playing the console does not start. I also tried to load from the evox autoinstaller, but the console is restarting. Do you have any ideas?
  6. Whether with a chip or without consoles have a frag. There were no tsop mods. One at the beginning after the purchase had a frag, after the next switch-on, but at the next attempt again frag. The second one had the cromwell chip loaded, there was no dash, I removed the chip made on the spider web and the phage appeared. I suspect that the problem lies on the side of the tsop load? I installed the aladdin for the second console, but the console was not started by the black screen.
  7. I already have a black screen, how to program an xchanger if it has a tsop_m7 bank deleted?
  8. Thanks for the answer The hard disk and drive is original Chip removed on both consoles, screen black so there is no obvious error.
  9. Hello, I have two xboxes, version 1.2 and 1.4 in both of them after the start Frag. They do not have a tsop. In one there was a chip for a spider web with cromwell, I soldered the chip and the console got Frag. In the second one, however, it worked but after replacing the past, it stopped competing. I tried to run both aladdin but it does not help, any ideas ?
  10. Hello, I have xbox ver 1.6, delta power supply gives 4,3 volt instead of 5v and the same drive hdd does not start. 12 volts is ok Capacitors have been replaced, but they are still the same. Do you have any idea what to check. The capacitor is 5v but on the output is already 4,3 volts
  11. Hello I have xbox ver 1.0, after unsuccessful tsop. The black screen turns on, I have an aladdin chip. I know that the topic has already been, can someone describe step by step how to program the chip and what? Gentoox + tsop_m7.bin of course recorded it on the CD?
  12. Hello, I was flashing the xbox version of the tsop 256 kb with the plug, half finished the process and after this the screen is black. I installed the xchanger chip, the console works, is there any chance to repair the tsop? Regards

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.