Jump to content

Tsop With Upgraded 160gb Hdd, G Partition Showing 0gb


Recommended Posts

Hiya, just TSOPed my 1.2v Oxbox and put in a 160gb hdd.  I split the F & G partitions 74ish gb each. 

The F partition show 74ish gb but G partion is 0gb.

Used HeXEn 18 and the  evox M8+ bios F+G, Both F & G values showed in XBpartitioner 1.3.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Content

    • By hands_groober
      Hi again
      Following up on my previous post about mt ram upgrade. Ive ran into another issue.
      I have installed a 1tb HDD. Prior to upgrading my ram I had already formated the with F partition taking 120gb and G partition taking the rest of the space. I have filled F partition with xbox games which has taken quite some time. Ive now realised that IND-BIOS 5003.67 will not read G partition.
      M8 bios will read the G partition but then i wont be able to take advantage of my extra ram. From what Ive read it is to do with how my G patition table is written. If this is the issue, is there any way I re-write the partition table without disturbing the data?
       

    • By rando
      Hi.
      When I try to boot into the dashboard the screen hangs on the xbox logo for a while and then displays the 07 error code 1 out 10 times/tries. Once I'm able to load the dashboard there are no problems. This problem has gotten worse over time and I am wondering if this points to a HDD problem. But the fact that once it has booted properly I can use it for hours with no issues or HDD failures which has me wondering if there are other issues here. The DVD searching sounds are pretty loud when I boot up the xbox.
      I seem to have an Aladdin XT 4032 modchip and a 1.4 or 1.5 xbox with a Focus video encoder chip.

      Any ideas?
      Help appreciated,
      S

       

    • By C64MidRezzie
      Upgraded to SATA drive - using 80 pin and Startech Ide to Sata - have the Startech on cable select - after the clubbed I get error 11 - tried master as well - cable loads older 250 ide cable - I’d say the adapter but I locked the drive using h it in an ok’d ide pc and it worked fine - I’m totally stumped and would really appreciate your expert advice - thanks!

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.