Search the Community
Showing results for tags 'strange'.
Found 3 results
So I have a crystal xbox, softmodded with what I believe to be a xecutr2 bios. It plays games from drive and disk. It won't allow me to clone the drive or boot up any hexen disk. After cloning the drive says it is locked in chimp but will not boot, it says error 13 unable to boot dash and Hexen just sits there, I know it takes a while to load have left it for half an hour but just sits with the led flashing red and the screen blank. Any one have any ideas (it does boot a copy of auto installerv1.01). Thanks.
Greetings! I am very new to the OG XBOX (both the console and the forums). I have a 1.4v xbox that I have dusted off recently to install Open Xenium chip. The console was a bit dirty, so I gave it a good cleaning, removed the clock capacitor (which had just started to leak), replaced the fan with a Nexus, and installed the new open Xenium chip. The system seems to be running great and immediately boots into the Xenium OS screen when powered on. The problem: no controller inputs are recognized in any of the controller ports (I've tried with four different working controllers). So basically I boot to Xenium OS, but cannot select any of the menu options. (I should also mention that before the Xenium install, everything had been working fine). Now, when this first happened, naturally my thought was that I had not properly reconnected the ports back to the motherboard, but upon checking they seemed to be well connected (I cleaned the ports and reconnected for good measure). I have looked at the traces on the motherboard and they seem fine. I imagine the chip install went okay since I can boot into Xenium OS(?) Port have been cleaned thoroughly. The only thing I have not tried is swapping the 1&2 ports with the 3&4 ports (in case there is a problem with port #1, and Xenium OS will only recognize input from Port #1???) Does anyone have any idea what the problem may be? It seems odd that none of the 4 controller ports are working, and all I am left with is an idle Xenium OS screen on my system. Could it be a single bad solder joint on the Xenium chip?Could it be that Port #1 is busted? Thanks for the help!
I wasn't sure whether to post this here or in repair, but since it happened during a TSOP mod I though I'd try here first. Picked up a 1.4 version at a Salvation Army today, green model worked great but filthy inside. Cleaned it up, removed clock capacitor and did the two TSOP points. Reassembled and before I even load into Hexen my video signal has lines going across the screen. After messing around I find that the problem is only with component output (hd output) and standard def av works fine. Thing is, component worked fine before I disassembled so I'm convinced the problem must have been caused by something I did - but all I did was pull the clock cap and do the 2 tsop points... Tried another component cable.. same result. Tried another tv, got a glitched looking display or 'mode not supported'. I'm convinced it's now outputting some garbled attempt at an hd signal that neither of my tvs can process correctly. Have 2 other xboxes and both display hd perfect with the same cables and tvs. I guess I can just sell it with some standard cables but losing the hd kinda kills the awesomeness so I'd really like to fix this if possible. This is like the second weird obscure xbox mystery for me in like a week, sheesh:)
Board Life Status
Board startup date: April 23, 2017 12:45:48