FluxedOut Posted June 10, 2022 Report Share Posted June 10, 2022 (edited) Hi folks, first time listener, first time caller. I recently inherited a 1.1 console and am going through the motions of getting it rounded out and looking pretty. I went ahead and did the Rocky softmod, and today I successfully converted it over to a 2TB 2.5" WD drive. No issues. I have the MakeMHZ XboxHD+ kit coming tomorrow along with modchip, so I figured I'd go ahead and get this 128MB upgrade knocked out. I'm not a novice solder head by any means, I do a lot of work with my station on a fairly regular basis. I installed all four RAM chips and went to test, got the crappy flashing lights and forced a boot into dash anyway. 2 of the RAM chips didn't pass. No big deal, powered the console off and went back to work. Once I was satisfied with my handiwork (reflowing, checking for bridging, etc) I put everything back together. Now I get no flubber startup, no audio, nothing. The light on the XBOX is solid green and shows no errors. I can't FTP into the XBOX either. Drive eject works fine, the NIC light is flashing in the back when cabled. I've tried the llamma coma tech as well (both sides) and that doesn't seem to force boot the system either. What should I do here? Edited June 10, 2022 by FluxedOut details Link to comment Share on other sites More sharing options...
FluxedOut Posted June 10, 2022 Author Report Share Posted June 10, 2022 Fixed, nevermind! Just needed to reflow around the general RAM areas. Link to comment Share on other sites More sharing options...
Recommended Posts