-
Similar Content
-
By DobaMuffin
Hello,
I am writing this today to see about getting some help with my 1.6 Xbox and the Xeceuter 2.6 CE installed in it. I recently did this Please login or register to see this link. involving a resistor to extend the life of the board and the board works fine after the install.
This is also where I managed to find an issue. With the mod chip enabled, both banks load up their respective bioses, but when I disable the mod chip using the front panel switch, the console Frags after 3 tries. When I disconnect the LFrame wire from the mod chip, the console boots up like normal to the stock dash using the stock bios. Before the mod though, disabling the mod chip using the front panel switch worked liked normal.
So now I am a point where I made a modification to extend the life of the console, but lost some functionality in my mod chip at the same time. I am wondering if anybody knows what would cause the issue I described and if anybody else has ever run into similar issues. Though I know most don't tend to mod 1.6 consoles if the can avoid it.
I'm also curious if anybody else happens to have an Xbox motherboard that is warped around the CPU and GPU area. By warped, I mean that I can see a curve in the motherboard around that area.
Thanks,
DobaMuffin
-
-
Board Life Status
Board startup date: April 23, 2017 12:45:48