OpenXenium Boot Problem after Case Reassembly

[mark01975]

hi again, some month later than first try on xbox 1.6, i had try again on another one 1.3, soldering was ok and a new one chip openxenium boots regulary, after reassembly the console, try to boot and the same sequence loop appear also on this new console...

solder pins was ok because first 3/5 boot was good

now the console loop boot until stops with blinking green leds, screen black and chip led don't turn on, if i unistall chip boot start correctly, on screen i can see the animation (until start hdd boot that i havent).

i'm so afraid because is the second one console that don't start.

Please someone can help me?

[KaosEngineer]

Post a few pictures of the pin header soldering on the bottom side of the motherboard.