Leaderboard

So do 28 & 29 need to be grounded for this to work?

Yes, correct installation pin 4 removed on header all soldering looks fine, have built 5-6 and have the same with all, tried the red wire connection as above no difference presume that's to remove write protection? Only other thing to try is the power fix diagram you have, although the power does seem fine at 3.29v at the chip.

This is the exact place I bought my chips from Italy, are these genuine? If so what else could be the issue here? They do boot fine with Cerbios when the 49LF020 is installed on an aladdin btw (the way I programmed the chip)

Excellent. I'll look into auto setting the clock. It's always connected to lan as it is now so shouldn't be an issue. Thank you all for your assistance.

I second that. It doesn't really work the way people think it does.

The TSOP recovery is very limited to what was flashed to it. It's not often successful to recover it using xblast pro. Much better to just lift the TSOP chip off the board and flash it or replace with a newly flashed one and solder back on. Save you a lot of grief really.

Can I just say, after a few very short emails to NeMesiS, they were able to completely blow me away with a modified version of this kit I'd like to post the results here on their behalf just to show what this kit looks like with a little bit of an Evangelion twist I'm very excited to receive this and continue with my themed console Excited for plastic