I am disappointed with the fan mods for the Original Xbox. I tried a 60mm Noctua Fan and then an 80MM Noctua, but no matter what i do. I cannot increase the speed of the fan. The fan just stays at the same speed settings even during gameplay. And was wondering if i can increase the speed of the Noctua since they are better,quieter fans capable of pushing out more air. I tried increasing the speed through the settings and through the config settings. But it still doesn’t make a difference. My Xbox has an Open Xenium modchip with Unleash X. Did i miss something? Do i need a special adapter?
I have an old Xbox that has an Xecuter 2 chip installed, it still has the stock HDD so i'd like to upgrade it to a 500GB SATA. Weirdly I cannot physically see any chip soldered to the board, I can see some yellow wires going out the front of the console so i'm not sure if this is where the chip is located? (see pic).
In any case I have downloaded the HeXen 2018 installation disc, and I have the necessary parts required to convert from IDE to SATA. Is this disc capable of setting up a HDD with this chip? I took a couple of pics showing my kernel and the fact my current HDD is locked:
I got a 1.6 Xbox off ebay today. Still works (minus the dvd drive, but I got several spare dvd drives), but the case is absolutely fucked in and out. After taking the controller ports out, I can't even put them back in - all but one of the posts for screws that hold the controller ports in are broken! I can only hold controller port 4 in with the intact post, all the other posts have big chunks broken off.
Is there anything I could rig up to hold the rest of the controller ports down, or bolt it down, or should I just try to find an intact 1.6 case?
Board Life Status
Board startup date: April 23, 2017 12:45:48