So I recently learned a valuable lesson about TSOP flashing when I flashed my 1.0 with iND-BiOS.Beta.Feb-11-05.67.bfm.bin rather than the non-BFM version of the bios. I was wondering what the practical purpose of the BFM (Boot from Media) bios is, and how one would even use it?
I'm assuming it is a BIOS that something can load AFTER the Xbox as already booted and initialized all hardware?

Hey all.  Sorry if this has been posted, but I searched and couldn't really find anything.  I have a 1.0 Xbox that was handed to me by a friend.  He said he couldn't remember much about it, but that him and his kid tried to mod it a long time ago, and now it isn't working.  Upon opening it, I found a pin header, no modchip, tsop points soldered, and the underside D0 pad ripped off.  When I try to start the xbox, it cycles power 3 times then frags out.  I'm assuming this is due mainly to the ripped D0 trace.  I've tried repairing the trace, and bridging the two pads connected by the green line, but I can't seem to get the solder to stick.  Is there any other way to repair this, or is this the only way?  Relatively new to xbox modding so any tips would be appreciated.  Thank you!  

Hi,
I have a hard modded OpenXenium chip with a 1 TB WD Blue HDD.  I have everything set up and I am trying to get more than 200 GB - with more than  > 200 GB left on a partition.  Filezilla is not letting me do that.  I am just trying to transfer the titles.  They are all HDD ready for transfer but they do not go through at a certain point.  They  all become failed transfers.  The bios I am using is unleashed x from the OGXBOX installer.  It was not flashed by the program but was transferred by my network.  It is a CEE bios.   I switch dashboard sometimes.  The only one that I have on there that is not preinstalled is Emulation Station. I had used the DVDmulleter to get the bios necessary.  The HDD has been partitioned correctly having being split from F to G the remaining left.  I am fairly new to this and any advice to help would be beneficial.