Jump to content
  • Similar Content

    • By Edge
      So I recently learned a valuable lesson about TSOP flashing when I flashed my 1.0 with iND-BiOS.Beta.Feb-11-05.67.bfm.bin rather than the non-BFM version of the bios. I was wondering what the practical purpose of the BFM (Boot from Media) bios is, and how one would even use it?
      I'm assuming it is a BIOS that something can load AFTER the Xbox as already booted and initialized all hardware?
    • By Chungaloid
      Hey all.  Sorry if this has been posted, but I searched and couldn't really find anything.  I have a 1.0 Xbox that was handed to me by a friend.  He said he couldn't remember much about it, but that him and his kid tried to mod it a long time ago, and now it isn't working.  Upon opening it, I found a pin header, no modchip, tsop points soldered, and the underside D0 pad ripped off.  When I try to start the xbox, it cycles power 3 times then frags out.  I'm assuming this is due mainly to the ripped D0 trace.  I've tried repairing the trace, and bridging the two pads connected by the green line, but I can't seem to get the solder to stick.  Is there any other way to repair this, or is this the only way?  Relatively new to xbox modding so any tips would be appreciated.  Thank you!  

    • By geohunk
      Hi guys,
       
       So I was given an Xbox 1.0 from a friend that is chipped and has a 120gb HDD. Unfotunately the chip does not have support for HDD larger than 120gb and I am unable to flash the chip's BIOS (evox says it is not flash writeable).
       I'm basically in a bind to find a guide on how to softmod this box and tsop it from a modchip because I don't know what type of chip it is and how to disable it. Pictures below: 
      Apologies for the very dusty MB, lol! As always any guidance will be highly appreciated.
       

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.