Hey all. Sorry if this has been posted, but I searched and couldn't really find anything. I have a 1.0 Xbox that was handed to me by a friend. He said he couldn't remember much about it, but that him and his kid tried to mod it a long time ago, and now it isn't working. Upon opening it, I found a pin header, no modchip, tsop points soldered, and the underside D0 pad ripped off. When I try to start the xbox, it cycles power 3 times then frags out. I'm assuming this is due mainly to the ripped D0 trace. I've tried repairing the trace, and bridging the two pads connected by the green line, but I can't seem to get the solder to stick. Is there any other way to repair this, or is this the only way? Relatively new to xbox modding so any tips would be appreciated. Thank you!
I have a hard modded OpenXenium chip with a 1 TB WD Blue HDD. I have everything set up and I am trying to get more than 200 GB - with more than > 200 GB left on a partition. Filezilla is not letting me do that. I am just trying to transfer the titles. They are all HDD ready for transfer but they do not go through at a certain point. They all become failed transfers. The bios I am using is unleashed x from the OGXBOX installer. It was not flashed by the program but was transferred by my network. It is a CEE bios. I switch dashboard sometimes. The only one that I have on there that is not preinstalled is Emulation Station. I had used the DVDmulleter to get the bios necessary. The HDD has been partitioned correctly having being split from F to G the remaining left. I am fairly new to this and any advice to help would be beneficial.
I have a Jet Set Radio Future save that I have played around 25 hours in that I would like to be able to play on my console, but I haven't been able to figure out how to resign the save. The save has an "error reading JSRF save data" and doesn't let me use my save. The save originated in Cxbx-R and it won't allow me to move the save to or from the console without this error occurring. Not sure how to proceed from here, and would be grateful if anyone wanted to help me out. I have attached the save if that can help, thanks for your time.
Board Life Status
Board startup date: April 23, 2017 12:45:48