Jump to content
Sign in to follow this  
cybrsrch

Red Green Flashing Light

Recommended Posts

I tried to mod my Xbox by doing the solder bridge mod to reflash the bios, I am now getting a flashing eject button red and green, I removed the solder bridges already, I also removed the capacitor for the clock. Any ideas what I can try to fix this?

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

  • Similar Content

    • By Noomi
      Hi,
      1.6 with Aladdin chip
      Thermal paste replaced
      120gb IDE hdd replaced with 1tb SATA (and Sata-IDE adapter plus 80-wire IDE cable) (Bought the xbox with chip and the 120gb hdd installed)
      HDD formatted properly, UnleashX installed
      All working beautifully, except for:
      When i try to IGR (in game reset) using either RT+LT+back+black or LT+RT+back+start the result is the same. It does not reset, it turns off, then turns on again but quite choppy ending with a green flashing front LED and nothing on the screen.
      Also, the red light on my sata-ide adapter goes on and off when it chops trying to boot. Then it goes to flashing green front LED with no light on the HDD (HDD not running i guess).
      Any thoughts?
      Thanks!
    • By SS_Dave
      This may be of interest to some. It saves having to Soft-Mod to flash the TSOP.
       
       
      I know is low quality video but you should get the idea
       
      SS Dave
       

      Those that can Hard-Mod. Those that can't Soft-Mod.
    • By excaliburlives
      Hello, i'm trying to finish up this Millennium Falcon mod i'm working on. I soldered a wire to the #39 pin to the negative leg of my led and the other leg of my led to the 12v and the 5v wires on my molex connector and light comes on but never blinks. It just stays on constant  What am i doing wrong?

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.