Search the Community
Showing results for tags 'changing'.
-
I have just taken the heatsink of a v1.0, cleaned it up and replaced with MX4. It seem to work OK but the heat sink is not clamped to the CPU at all well. I can rotate it with no trouble and even rock it side to side. Were the original thermal pads adhesive? Were they 1mm thick and I need to now pack the clamp out? Any thoughts? Thanks.
-
Hello you all, I had an idea, that involved getting an Aladdin XT 4032, and replacing the Lattice chip with an LC4064V one. I was wondering, that after flashing the chip with a JTAG programmer, that the chip would function similarly to an Aladdin Xt 4064, or not. I don't want to go into this, and end up wasting a few dollars, because I didn't ask for help before doing this.
-
I have a 1.0 Xbox with an Xecuter 1.1 modchip installed. Used the Truhexen disk to install a brand new sata drive no issues. Trouble i am having is getting tge xbox to boot automatically to UnleashX. It only boots to the normal MS dash no matter what I select in Truhexen as my default dash. Have tried Slayer and AID clean installs choosing UnleashX but also always boots to normal MS dash. What am I missing? i did remove clock capacitor but i dont think that should matter
- 19 replies
-
Just a quick question guys and girls, i would like to swap my dashboard from UnleashX to EvoX, my setup is v1.2 Xbox (Softmod), is it just a simple case of popping in Hexan or Slayers installer disk in installing EvoX. Thanks all for your help, i appreciate it a lot.
-
Hi i messed my xbox up by deleting files off the c drive and to cut a long story short ive managed to get it running again using the hexen disc, i want to boot into XBMC4GAMERS which i have on my E drive, trouble is there is no default.xbe on my c drive? there is just a IND bios config which says the following DASH1=\Device\Harddisk0\Partition2\evoxdash.xbe DASH2=\Device\Harddisk0\Partition1\Dash\UnleashX\unleashx.xbe DASH3=\Device\Harddisk0\Partition1\Dash\EvolutionX\evoxdash.xbe DEFAULTXBE=\Device\CdRom0\default.xbe not sure why it says default xbe in cd rom because i have removed the Hexen disc? any help would be appreciated.
Board Life Status
Board startup date: April 23, 2017 12:45:48