Jump to content
OGXbox.com

obitus1990

Members
  • Posts

    7
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

obitus1990's Achievements

Newbie

Newbie (1/14)

2

Reputation

  1. OK, I would like one if there is still one available. PM me.
  2. Sorry for the double post, but, after looking inside a couple of the archives, some have .jed files in them, which is the CPLD code, I assume.
  3. You could always just program it with XBLASTOS, I suppose.
  4. I located a broken/corroded trace along the front edge of the board. I ran a jumper wire from that last resistor prior to the drive transistors to a distant point on the board along that trace, and it now works properly. I found those hi-res scans especially helpful, as figuring out where some of those traces ran on an populated board was proving to be next to impossible.
  5. KaosEngineer, Do you have a schematic for a 1.0 board? I have a similar problem with my version 1.0. The green portion of the LED does not illuminate, only red. I can trace them back to check continuity if I have a proper schematic. THanks!
  6. Questions: 1. Is it possible to remove the cover of the X3 switch without damaging the anything? I think my DIP switches are faulty, and, want to replace them. 2. Do you have part numbers/descriptions/names for the types of wire connectors used on the X3?

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.