Jump to content

Welcome to our site

Take a moment to join us. You can sign in with Facebook with a couple of clicks. No need for a lengthy registration. We also have Tapatalk support so you can use this forum on your phone the same way you use facebook. It will keep you notified.

Sign in to follow this  
psnap777

Softmod Installer Deluxe V5.11

Recommended Posts

Hi Guys. I'm new to modding the XBOX. Just soft modded a V1.1 XBOX and using Softmod Installer Deluxe v5.11. Everything seems to have gone fine but now the light around the eject button is solid orange and the eject button doesn't blink when the dvd drive is reading a disk. From what I have read, this seems to be normal after modding and I have also read about where to go into settings to adjust the lights. But what I have not been able to do is figure out how to get it back to looking stock. In other words, I just want the light to be solid green when booting up and while running, and have it flash green when the system is busy. I have tried setting it this way in settings but it doesn't seem to work. I'm not sure what I'm missing. Any suggestions would be greatly appreciated.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

Board Life Status


Board startup date: April 23, 2017 12:45:48
  • Similar Content

    • By psnap777
      I have softmodded a v1.1 XBOX with a Sharp TSOP using Softmod Deluxe v5.11 and have experienced a few issues:
      When sending files to the XBOX via Filezilla, the system frequently freezes and sometimes restarts. This happes especially with large files. The lights around the eject button behave differently than stock. When I make changes in settings they don't seem to work. For instance, even when I set it to do so, the light around the eject button will not flash when the drive is busy. Also, even when I set the light to be green, it is green when I first turn the system on, then changes to orange while the softmod is booting then turns back to green again. When I make changes to settings in the settings menu of the UnleashX dash, they don't carry over to the settings menu in the softmod menu. I find I have to make setting changes in two places. Have you guys experienced this? Is this normal for this softmod?
      Which softmod do you guys prefer between NDURE and Softmod Deluxe? If I want to switch to NDURE, do I select the remove softmod option in Softmod Deluxe, then install NDURE? Or can I install NDURE over Softmod Deluxe without removing it first.
      (I've decided to just leave this XBOX softmodded since it has the Sharp TSOP chip which is more involved in TSOPing than the others.)
      Thank you very much for all of your help and advice.
×

Important Information

By using this site, you agree to our Terms of Use.