Ich brauche Hilfe beim Einbau des xtender. Es soll in eine v1.1 eingebaut werden leider finde ich keine Anleitung alle Links down 

I got a SPI2PAR2019 kit and an HD44780 compliant screen and tried to wire it up last night but ran into some problems. The LCD just shows zeroes on the screen. When it first powers up, I see 2 of the 4 lines filled with solid-square characters (two full rows of solid boxes, rows 2 and 4). Then after the Xbox boots up further, the screen goes blank, then shows zeroes (see photo). I'm also seeing some flickering on the screen showing the zeroes.
I checked the wiring diagram of the LCD I'm using and verified that points #1-16 correlate to points #1-16 on my LCD, so I don't think it's that. I also tried powering the arduino with a USB battery bank and that didn't make any difference. I have a 2nd LCD that showed the same issue. I have a 2nd spi2par but haven't wired that in yet. I've enabled LCD options in XBMC to no avail.
SPI2PAR2019 from Please login or register to see this link.
White on Blue 20x4 LCD Character Display from Please login or register to see this link.
Wired through an OpenXenium modchip.
Thoughts:
Shorten wire going from spi2par to LCD. Try getting rid of the wire entirely and just soldering the spi2par straight onto the back of the LCD. Perhaps the spi2par doesn't come pre-programmed? Not sure how to tell if it is or not. (I asked the seller for details) Please login or register to see this attachment.
Please login or register to see this attachment.
Please login or register to see this attachment.
Please login or register to see this attachment.

I'm back with what I believe is v1.5 installed pin header and placed mod chip on it. When I start it up it starts up as if there is no chip. Seams like something keeping from booting from the chip. Any suggestions or advice?