Jump to content
  • Similar Content

    • By FerociousOG
      Unable to flash BIOS. Error reading bios file (see pic). To me it sounds like I have a bad DVD burn? Just wanted to confirm. I did burn at the slowest write speed. Will re-burn again.
      -v1.1 mobo
      -XeXEn 2018
      -Using Verbatium DVD+R media
      -Attempting to flash iND-BIOS.5004 (F and G) to use 2TB SATA HDD.

      Thanks in advance.
       
    • By Listai
      Please login or register to see this link.
      Hi everyone
      Yesterday I ran into an issue with my install - I have a 1.6 Xbox so I picked up an Aladdin XT and a rebuild board to make the job easier. Should be easy right? - apparently not as I stuffed it up. Basically I made the mistake of following a video where the rebuild board had a much larger space around the pins which allowed for quite a bit of solder to be flowed onto them - I followed those instructions and when I went to put my board on it didn't sit flush. So for whatever reason I decided to solder it in and see what happened.
      Naturally, it didn't work so I with armed with a lot of patience and a desoldering wick I managed to remove it without destroying any pads or traces - but I have another problem. I didn't remove the unnecessary pin headers for my 1.6 - will the chip still work? and do I need to solder all of the pins to the rebuild board (I'm confused about the plating corresponding to each of the pins) as I'm not sure if I can remove them as you can see from the image the solder has gone directly into the through hole and I don't have the means of removing it.
      Sorry if this is stupid but I barely managed to get the header off of the board (thankfully I ordered extras) I don't want to have to desolder another one of these.
      Thanks!
    • By Paw
      Hi guys i just found my old xbox in the basement and by the look of things it looks like its hardmoded with a Xecuter chip and there is even a 120gb drive installed and all is working without any issues. My main question is if anyone here could help me identify what kind of Xecuter chip this is, because my plan is that i would like to replace the 120gb drive with a 1tb but im getting a LBA48 warning when i try to partition the new disk and its asking me to ugrade the current bios with a new one that supports LBA48.
      Current INFO:
      Bios: Xecuter2 4976.02
      Kernel 1.00.5838.01
      Xbox v1.1
      What would be the best course of action, how should i approach the reflashing, what bios should i pick so that the new 1tb drive works as intended and ofcause what should i think about when i approach all this?
       
       
      Please login or register to see this attachment.
      Please login or register to see this attachment.
      Please login or register to see this attachment.

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.