Search the Community
Showing results for tags 'phillips'.
-
I took apart three consoles today that where sold as parts, all three had Phillips drives in them but one was a V1.0, all the research I've found says this drive only started at V1.1. The seals were intact, I was the first to open it up.
-
Hi all, first and foremost, as the season approaches I want to wish everyone a happy holidays! I bought a "for repair" 1.1 unit that needed a LOT of work. (This is a different unit than the Sharp TSOP unit from my other repair post.) Luckily I was able to repair everything except the Philips DVD drive. It was relatively clean - I cleaned the lens, replaced the drive belt and cleaned up a bit of corrosion on the board, but it's still dodgy. Question, can this Philips drive be saved? On startup there is a high-pitched whine from inside the dvd drive, and when I push the eject button, it wants to open and close, but it will only travel about an inch or so and stick, then if I keep pushing the button it will eventually open fully but refuse to close again. Is this a control board issue, or a motor issue? I rarely encounter DVD problems, so this is a new one for me. Thanks all!
-
Strange I am unable to read burnt discs with Phillips DVD drv on the 1.4 but originals boot fine. No issues with Issues with Phillips DVD drv on 1.1. Do I have to apply a patch to DVD drv? If no I will try another DVD-R burner on slowest speed. Thanks in advance.
- 1 reply
-
- phillips dvd
- burnt discs
- (and 9 more)
-
i found some new lasers for phillips drives and bought some. these were brand new because i had to desolder the esd protection solder points on it. i replaced the laser in a drive that would not work at all and now it is working. however, it won't read any disks that have any kind of serious damage. my old samsung and hitachi will play them fine but they have to be almost perfect for my phillips to read them. i have heard about how phillips turn the laser strength down in an attempt to prevent the from reading cd-r disks(fyi, i'm only trying to read official xbox disks). my question is, should i adjust the pots on this new laser so that the laser is stronger? i've heard that will shorten the life of the laser but i'm wondering if they were even turned up high enough in the 1st place?
Board Life Status
Board startup date: April 23, 2017 12:45:48