Search the Community
Showing results for tags 'every'.
Hi, been using this install for ages with no issues. Today after moving from one tv (on component) to another tv (on RGB, don't know if this is important) xbmc4gamers is asking me to calibrate the screen. I do this, it asks to restart, then when it starts up again it is asking for calibration again, then reset and so on, stuck in a loop. Is there a way to bypass this, or maybe a config file to change or delete that will let me back in again? I notice after calibration finishes and the restart dialogue comes up, there is a notification in the top left that says 'script failed'. Asking here as its likely an easy fix for those with the knowhow! Thanks again folks!
Hey guys! I've got a couple boxes I threw some SSDs into recently and they don't load the dash, but as it says on the tin, only every OTHER time I turn it on. Startup works normally up until AFTER the "X" logo. Either the LED will stay solid green, and the screen will just be completely black forever (to be fair, only ever left it for about and hour while I was doing other stuff for giggles) OR the LED goes solid red like I've set it and loads UnleashX A-okay. Things both run like a champ in this state, haven't seen anything unusual, even the temps are great with stock paste. This happens with: - 2 brand new ADATA ASU655SS-480GT-C units, both of which were cloned from an IDE-based box with a 750GB seagate. The system they were cloned from was 1.6, softmodded with SID5, then upgraded to Rocky5. No issues on that console. These drives have NOT been tested in other functional consoles. Yet. - Three 80-wire IDE cables, two of which were running active duty in other consoles prior to testing and one of which died for some reason during the test. - Four IDE-SATA adapters - an HDE, a Startech IDE2SAT, and 2 Startech IDE2SAT2s (I haven't gone through the trouble of comparing ALL adapter and cable combos but at this point I don't think it matters) - A 1.4 and 1.6 version console - UnleashX Version 0.39.0528A Build 584, as installed by Rocky5's softmod The fact that the LED stays green on the failed boot seems like the system somehow things everything is normal and the SSD has just... stopped? Somewhere? I'm not sure. I think maybe this could be related to the BIOS or DVD drive, as both consoles are only softmodded. I plan to TSOP the 1.4 anyway, but I can't TSOP the 1.6 or (easily) remove its DVD drive, which I'm not inclined to do anyway as it works great. Wondering if anyone had some suggestions I perhaps haven't tried yet. Thanks so much for any and all assistance!
Board Life Status
Board startup date: April 23, 2017 12:45:48