Leaderboard

Hey guys, made an instruction for the "Analog2HDMI" mod from Electron Shepherd LLC. 1. Remove AVIP Socket from your Mainboard: 2. Modify AVIP Socket: 3. Add Analog2HDMI to AVIP Socket, make sure to flip Analog2HDMI otherwise you might have problems with the Mainboard. 4. Use hot glue to attach Analog2HDMI and AVIP Socket, just leave the space for the wires between Mod and Mainboard. 5. Solder your Mod to the Mainboard, use this digram: IMPORTANT: Use all the Ground (GND) i use! Add an extra wire (GND) between HDMI Socket of Analog2HDMI and Mainboard if the RF shielding doen't touch the HDMI Socket, otherwise you will most likely get image error. 6. Congratulations to your new HDMI mod! Hope you can work with this!

If you are fitting a Open Xenium then you can leave the track cut bit, The reason for cutting the trace is because the cheaper modchips hold the D0 to ground and that may possibly put stress on the MCPX chip on the main board where the Open Xenium only grounds the D0 at boot and then the D0 returns to normal after booting. Cheers SS Dave Soft modding is like masturbating, It gets the job done but it's nothing like the real thing.