Leaderboard

Hi folks, Thought I'd share a pic of a nice Newhaven Display OLED which works nicely with the OpenXenium for me. I just used the Arduino Pro Micro but not on the spi2par2019 board, since it's oled (no backlight etc), plus it's no use anyway since oled has a 20 pin varied connector that doesn't match obviously. You need to be careful setting the pins up. It's using the same hd44780 parallel 6800 4-bit interface (not i2c) - I just set the oled using jumpers soldered on the back as per pdf. I added the initialisation code into the .ino and changed some of the hd44780 commands up as well. You also have to edit the liquidcrystal library too - bit of a faff, I'm no coder but managed in the end after a week. You can get it on Mouser etc, different colours. Ugh it's £22.80 plus the vat though Rough first youtube vid on ipad - turn up volume.

With the modchip removed and the drives (DVD, HDD) disconnected the Xbox should boot with the flubber animation and then display a service required screen with a error number Also the D0 wire may have been dislodged from the main board especially when it soldered to the top of the board while you have been working on it or the chip has not been soldered correctly and has a bad solder joint. Can you post a pic of the main board. Cheers SS Dave Soft modding is like masturbating, It gets the job done but it's nothing like the real thing.

It's not just you, dremel's has a mind of their own. Cheers SS Dave Soft modding is like masturbating, It gets the job done but it's nothing like the real thing.