Search the Community
Showing results for tags 'mod.'.
Found 2 results
lockar posted a topic in SoftmodsHi, I was wondering about this new dumb newbe question. Do I have to hard mod my original Xbox for me to put in a bigger HD in it? From what I could find on the internet the answer is yes, but I came across other videos that say no. So now I am confused. Also when I soft Mod my xbox the ring not turns green at start up, but when I get the menu it turns yellow? Everything works fine, plays games fine and stuff. Should I be concerned about this? Thanks! -Lockar
Ever wanted to add a new D-pad to your controller? Probably not. But im still gonna show you how. Both methods are on an S-Controller. I haven't tested on a Duke or any other controller. If you wanna try then let me know how it goes. Tools/Materials You'll need for this mod Phillips Head screw driver mini Phillips head screw driver Regular D-pad from an xbox 360 Controller or A Transforming D-pad from a 360 Controller (Depending on which mod you wanna do) Needle Nose pliers or Wire cutters(For method 1) Dremel/Rotory tool Sanding Barrel and cutting disc for your Dremel. and 10-15 minutes of your time. PART A: Disassembly First you'll need to pull apart your controller. there are 7 Phillips head screws on the bottom, 1 is under the barcode sticker in the center. once removed you can pull the bottom part up and remove the internals. Once you have everything stripped from the top half of your shell you'll need your Mini Phillips head screw driver. remove the 2 screws holding your original d-pad in place and pop it out. Part B: Mod Method 1 Now take your new 360 d-pad and look at it . the one on the left is the original S D-pad. right is from the 360. You'll want to remove the locating tab on the right side using your cutting disc. Alternatively you can snap it off with a pair of needle nose pliers or even some wire cutters. Now pop it in and reassemble everything. Your done!! This mod isnt really for the Original colored D-pads (Grey or Black) But once done you can buy many different colored ones for the 360 controller. Great if you plan on painting your controller. Part C: Mod Method 2 First you'll need to pull apart your controller (Refer to Part A) Once taken apart you'll need to take your Dremel with the sanding barrel and remove the internal part of the d-pad mounting location. Go slow and take your time. Don't cut any deeper than whats in the picture. If you cut too deep you will ruin the controller. all you wanna do is cut/sand it down smooth to the cylinder wall.(If that makes sense) Now you'll need to flip your controller over, and put the new D-pad into place. You'll notice the locating pins are preventing it from going in. You'll want to take your cutting disc and cut notches in the Controller so the D-pad can go in. (I cut to vertical slices and then used my screw driver to snap the piece off) Not the cleanest way to do it, but it works. Once the notches are cut you should be able to put everything back together (Using the original Rubber insert for the d-pad) and you are done!! Enjoy your new Transforming D-Pad!
Board Life Status
Board startup date: April 23, 2017 12:45:48