Hey all. Sorry if this has been posted, but I searched and couldn't really find anything. I have a 1.0 Xbox that was handed to me by a friend. He said he couldn't remember much about it, but that him and his kid tried to mod it a long time ago, and now it isn't working. Upon opening it, I found a pin header, no modchip, tsop points soldered, and the underside D0 pad ripped off. When I try to start the xbox, it cycles power 3 times then frags out. I'm assuming this is due mainly to the ripped D0 trace. I've tried repairing the trace, and bridging the two pads connected by the green line, but I can't seem to get the solder to stick. Is there any other way to repair this, or is this the only way? Relatively new to xbox modding so any tips would be appreciated. Thank you!
So I was given an Xbox 1.0 from a friend that is chipped and has a 120gb HDD. Unfotunately the chip does not have support for HDD larger than 120gb and I am unable to flash the chip's BIOS (evox says it is not flash writeable).
I'm basically in a bind to find a guide on how to softmod this box and tsop it from a modchip because I don't know what type of chip it is and how to disable it. Pictures below:
Apologies for the very dusty MB, lol! As always any guidance will be highly appreciated.
Hi all,
I joined just over a year ago, and just realized I've never posted before. Thanks to this site and a few others, I TSOP-flashed a v1.0 XBOX and upgraded to a 2TB hard drive. Now I'm in the process of trying to streamline as many of my consoles as possible to use HDMI.
Recommended Posts
Similar Content
So I was given an Xbox 1.0 from a friend that is chipped and has a 120gb HDD. Unfotunately the chip does not have support for HDD larger than 120gb and I am unable to flash the chip's BIOS (evox says it is not flash writeable).
I'm basically in a bind to find a guide on how to softmod this box and tsop it from a modchip because I don't know what type of chip it is and how to disable it. Pictures below:
Apologies for the very dusty MB, lol! As always any guidance will be highly appreciated.
I joined just over a year ago, and just realized I've never posted before. Thanks to this site and a few others, I TSOP-flashed a v1.0 XBOX and upgraded to a 2TB hard drive. Now I'm in the process of trying to streamline as many of my consoles as possible to use HDMI.
Cheers,
Cliff
Board Life Status
Board startup date: April 23, 2017 12:45:48