Jump to content
  • Similar Content

    • By onimush
      Do I understand correctly that the processor in og xbox is the same as the BGA part of the slot 1 cpu?
      If so, using a soldering station, we can, for example, change cpu to a full P3-733mhz 256kb. On a pc, replacing the cache from 128kb to 256 gives an increase in games of 15-30% (if we compare celeron 800/128/100 and p3 800/256/100). Such upgrade does not create speed problems in games. Am i wrong?


    • By Chungaloid
      Hey all.  Sorry if this has been posted, but I searched and couldn't really find anything.  I have a 1.0 Xbox that was handed to me by a friend.  He said he couldn't remember much about it, but that him and his kid tried to mod it a long time ago, and now it isn't working.  Upon opening it, I found a pin header, no modchip, tsop points soldered, and the underside D0 pad ripped off.  When I try to start the xbox, it cycles power 3 times then frags out.  I'm assuming this is due mainly to the ripped D0 trace.  I've tried repairing the trace, and bridging the two pads connected by the green line, but I can't seem to get the solder to stick.  Is there any other way to repair this, or is this the only way?  Relatively new to xbox modding so any tips would be appreciated.  Thank you!  

    • By Skrumpkin
      Hi,
      I have a hard modded OpenXenium chip with a 1 TB WD Blue HDD.  I have everything set up and I am trying to get more than 200 GB - with more than  > 200 GB left on a partition.  Filezilla is not letting me do that.  I am just trying to transfer the titles.  They are all HDD ready for transfer but they do not go through at a certain point.  They  all become failed transfers.  The bios I am using is unleashed x from the OGXBOX installer.  It was not flashed by the program but was transferred by my network.  It is a CEE bios.   I switch dashboard sometimes.  The only one that I have on there that is not preinstalled is Emulation Station. I had used the DVDmulleter to get the bios necessary.  The HDD has been partitioned correctly having being split from F to G the remaining left.  I am fairly new to this and any advice to help would be beneficial.

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.