Search the Community

Thank you in advance for any and all help provided, So I installed a X3 chip along with the LCD face plate that has USB on my v1.0 Xbox (not windbond/Sharp). I managed to flash bios to the chip but I am unsure of how to understand the bank switches. Bios checker always show unknown bios. I get Evox Bios to load when all 4 switches lights are on. I get X3 Bios to load when switch # 2 lights is on. Every other switch combination my Xbox just powers cycles on/off 3 times with power button flashing before it shuts down. I can't even get to the flash Bios menu anymore. So my questions are.... Question 1: On the face plate are my switches are ON if they light up or are they OFF if no light is on! Is this correct? I don't see the on/off wording on it. Question 2: How do I determine where to flash a Bios? 256k/512k/1MB/2MB? Question 3: The graph description below shows what bank you are on depending on the switch combination, yes? 256k Bank Bank 1: on on on on Bank 2: off on on on Bank 3: on off on on Bank 4: off off on on Bank 5: on on off on Bank 6: off on off on Bank 7: on off off on Bank 8: off off off on 512k Bank Bank 12: on on on off Bank 34: off on on off Bank 56: on off on off Bank 78: off off on off 1MB Bank Bank 1234: on on off off Bank 5678: off on off off 2MB Bank Bank 12345678: off off off off

@Rocky5 Unfortunately, the LED color on the powerbutton switches automatically back to it's regular "green color" if you start a game. (LED1) Can you fix this or is there any option to "lock" the color in the system setup? Big issue for Consoles with LED Mod Just to make sure, I know how to change the color in the system setup, but you can change it for example to red and if you start a xbox game it switches to green, it stays red in any other emulator or homebrew or the main menu of XBMC4Gamers.... but not in XBox games. Thanks for your kind attention!

Hello All, I have a xbox that i picked up used, and it has a xecuter pro 2.1 (i believe) but it does not have the front or rear rs232 or DIP switch plates. When i boot i get an error of an unlocked drive, so I assume it is trying to boot to factory BIOS and it has a WD 120GB IDE drive in it. I tried to jump the D0 wire to ground as I read that would force it to use the xecuter's bios, and when I do that I get a greyscale screen that "xbox Linux Clean BIOS 1.22dev" screen that tells me to put in a disc. is this something i can do with Hexen? Thank you for any help