Search the Community
Showing results for tags 'adaptor'.
Found 2 results
I have a TSOPED Xbox PAL console and it is running the 2TB Origins image. I had previously set the the video mode to NTSC and was using the HD resolutions fine no problem with a HD component cable, only trouble was the cable was not good quality and caused a lot of buzzing sound through my speakers. So I bought the Bitfunx HMDI adaptor (think it is similar, if not same as the Pound one). Problem I have now is that I can't seem to use it and display in NTSC HD modes at all. If I set the console to PAL the Xbox shows the EVOX boot screen and then loads the dashboard fine (obviously only in the lowest res PAL mode) If I set the console to NTSC the Xbox shows the EVOX boot screen but then the dashboard won't show as it appears the TV is not receiving a HD signal. I am stuck, is there anything I can try? Thanks in advance.
So my previous setup was using a cheapo sata/ide converter with a 80 wire cable, which actually worked pretty well, I haven't had any issues with it, but I decided to try the startech adapter too just to see if there was in fact a difference in loading times instead and I encounter a weird issue. I'm running IND 5003 bios and when I boot the xbox the flubber animation is very choppy and the audio doesn't sync up. It does load to the dashboard but the boot-up is pretty glitchy. I tried another ide cable and messed around with the pin settings with no avail. I could just disable the flubber animation but I'd like to try and get it running smoothly. Any help would be appreciated. Thanks!
Board Life Status
Board startup date: April 23, 2017 12:45:48