Jump to content
OGXbox.com

Search the Community

Showing results for tags 'red/green'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Rules
    • Why Can't I Download?
  • Subscribed Members Only
    • Subscribed Members Only
  • Off Topic
    • New Member Introductions
    • Rumble Pit
    • Suggestion Box.
  • General Xbox Discussion
    • General Xbox Discussion
  • Original Xbox Modding Forum
    • Hardware Mods
    • Modchips
    • TSOP Flashing
    • Softmods
    • Repair
  • Xbox Case Modding
    • Case Mods
    • Lighting & Electrical Mods
  • Tutorials
    • Official Tutorials
    • Tutorial Submission
  • Software
    • Bios
    • Dashboards
    • Installation Disks
    • Applications
    • Games
    • Emulators
    • Homebrew
  • Xbox Collecting
    • Xbox Collection Showcase
  • Rare and Uncommon
    • Rare and Uncommon Xbox Hardware
    • Rare and Uncommon Xbox Software
  • Vendors
    • N64 Freak's Products
    • Barnito's Products
  • Development
    • Rocky5's Projects
  • Online Play
    • Game Night
  • Classifieds
    • Wanted
    • For Sale
  • Moderator Section
    • Moderator Back Room

Product Groups

  • Vendor Forum
  • Membership Subscriptions
  • Forum Ads

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


About Me

Found 4 results

  1. Hello everyone. I just finished TSOPing an Xbox model 1.1 and decided I wanted to flash Cerbios 2.01 Retail, and after flashing I have a red/green flashing light with no picture. The system is hooked up via composite (yellow, red and white) video cables and now I have no picture. I cannot access FTP, either. I was also sure to FTP over the Cerbios.ini and boot animations to the root of C ahead of flashing. Can anyone help or point me in the right direction? Thank you.
  2. Hello everyone, A while back I bought a couple of Xbox's 1.0 , 1.3 & a 1.6 . Fixed the first two up and running , now the last one turns on and off 3 times, then flashes red/green without video, previous owner says it had the error 06 but for me It doesn't give a video signal at all. A visual inspection of the board for any bulged capacitors shows no obvious faults, although I am aware that sometimes with an ESR meter (which i dont have) you can tell which is good and which is bad. I'm using a component cable and the V1.6 xbox is a PAL unit and the hard drive inside is definitely not stock 160GB storage and no hard mod is installed. A quick search gives me the idea that its probably the eeprom ( dead or corrupted ) if that is the case and assuming i have no backup as i do not know what the previous owner did to it, what should i do ? if not any ideas what should i check / do to troubleshoot the problem ? . I have a Rpi , arduino and an old eeprom universal flasher ( i will check if it supports the chips ). Oh and i have an Aladdin XT PLUS2 on hand if that would help , but kindly note that I have never used them before but if someone has a guide that would be appreciated as well. Best Regards SP
  3. So I've finally decided to pull out my old 1.6 Xbox which I got from a friend who modded it again. It doesn't boot up properly anymore. No video output and it boots up and shuts back down 3 times before it turn to a red/green flashing icon. Disk tray works normally, I can hear the HDD spin up, but I haven't been able to test it yet. I'm at a loss what to do. Here is a picture of the mod chip:
  4. I have a xbox. I softmodded then removed softmod. All went well. Softmodded with unleashx and later removed. All was fine. Then yesterday went to softmod with sid. In middle of process or at end xbox shuts down like normal. Then turned back on and now red/green flashing ring and video is not working. Any ideas? I have tried letting the clock reset but made a sure not to leave the console off more than about 5 to 10 minutes. I have left it on all night trying to find a solution. I am worried if I unplug it or power it off much longer it may turn into a brick. Any ideas? I loaded and backed up everything correctly. I have 2 video cables and checked that as well and no dice any help would be appreciated. The video im sure went out with the new softmod install. Not sure why. Any help would be appreciated. Id rather fix than throw it at the wall lol.

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.