Jump to content

Welcome to our site

Take a moment to join us. You can sign in with Facebook with a couple of clicks. No need for a lengthy registration. We also have Tapatalk support so you can use this forum on your phone the same way you use facebook. It will keep you notified.

barnito

Ownmod Schematics for Tsop Recovery

Recommended Posts

barnito    12

use an eprom (27C2001/27C020 or bigger) or flashrom (29F020 or bigger)

 

connect pins 22, 24 and 31 of the eprom to GND (pin 16 of the eprom). 
you might have to connect 31 to 5V (pin 32) if you are using a flashrom.

Reset is A18 on this diagram.

image.png.46fca1b65801e08e25bde7660befbfa7.png

image.png.8404b4197f97e27980e9ebb45ffa5e68.png

FOR XBOX v1.0/v1.1

The two unused points are only two additional Adress-Lines for the Chip (with which you can access everything beyong 256 kByte) ... so they are NOT needed.

eprommod2xs.jpg

eprommod3xs.jpg

eprommod4xs.jpg

FOR XBOX v1.2/v1.3 (Thanks to D-BlooD who posted this diagram on Please login or register to see this link. )

v12.JPG

FOR XBOX v1.4/v1.5 (Thanks to pcmerc who posted this diagram on Please login or register to see this link. )
WE is the location you jump on the bottom of the board along with the other point on top that is standard on all motherboards. These are the write enable for reflashing the TSOP.
Pad 33 is also known as link to 32 in previous pinouts.

v14_15_xbox.jpg

 

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

    • By Dave C.
      Can someone please confirm that only the Pads at R7D3 (on the top of the board) and the Pads at R7R3 (on the bottom of the board) need to be soldered and there is no jumper wire or other modifications needed if the TSOP is a Winbond TSOP and not a Sharp TSOP.
    • By TotalMoop
      Just interested in which bios you flashed?
      I've used the Hexen 2017 disc and followed a tutorial on YT which suggested the M8 Evo x
      What are your suggestions and recommendations... and also why? i.e. what benefit, features etc...
      Thanks
       
×

Important Information

By using this site, you agree to our Terms of Use.