Jump to content
  • Similar Content

    • By beamsbox
      So, I've been at this LCD all day. Didn't work at all this morning. Cleaned contacts, added a bit of pressure to the tabs behind the screen. Now I have a magic lcd screen - when I move my hand close to the rear of the lcd, all pixels populate, crystal clear, but when I remove my hand, the bottom letters dwindle away...
       
      See here: https://youtu.be/C_iVmE75Wog
       
      Is there any hope? Any ideas?
    • By tlon
      Dusted off my Xbox for the kids today - powered it up, it defaulted to MS dash and prompted me for the date and time (good thing, I recall the nightmare of endless loops last time)
      Set the date, time, played a little Dance Dance Revolution on the native bios with the DVD-Rom (original media)
      Expected to power the Xbox off, hit the eject button, and boot into Xenium/EvolutionX or whatever I last had installed on the dash... but only get the stock MS dash, and no signs the modchip is functioning.
      Pulled the torx screws (had to find my screwdrivers) and opened it up.  Modchip is installed on LPC header with single wire soldered to the topside of the board.   Re-seated the modchip since I was in there, closed it all back up, hooked it back to the TV... still nothing but stock.
      Most likely cause of no-mod-signs-of-life?
       
    • By GoTeamScotch
      I got a SPI2PAR2019 kit and an HD44780 compliant screen and tried to wire it up last night but ran into some problems. The LCD just shows zeroes on the screen. When it first powers up, I see 2 of the 4 lines filled with solid-square characters (two full rows of solid boxes, rows 2 and 4). Then after the Xbox boots up further, the screen goes blank, then shows zeroes (see photo). I'm also seeing some flickering on the screen showing the zeroes.
      I checked the wiring diagram of the LCD I'm using and verified that points #1-16 correlate to points #1-16 on my LCD, so I don't think it's that. I also tried powering the arduino with a USB battery bank and that didn't make any difference. I have a 2nd LCD that showed the same issue. I have a 2nd spi2par but haven't wired that in yet. I've enabled LCD options in XBMC to no avail.
      SPI2PAR2019 from ChimericSystems.com
      White on Blue 20x4 LCD Character Display from CrystalFontz.com
      Wired through an OpenXenium modchip.
      Thoughts:
      Shorten wire going from spi2par to LCD. Try getting rid of the wire entirely and just soldering the spi2par straight onto the back of the LCD. Perhaps the spi2par doesn't come pre-programmed? Not sure how to tell if it is or not. (I asked the seller for details)



Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.