Search the Community
Showing results for tags 'setting'.
Found 3 results
I have a TSOPED Xbox PAL console and it is running the 2TB Origins image. I had previously set the the video mode to NTSC and was using the HD resolutions fine no problem with a HD component cable, only trouble was the cable was not good quality and caused a lot of buzzing sound through my speakers. So I bought the Bitfunx HMDI adaptor (think it is similar, if not same as the Pound one). Problem I have now is that I can't seem to use it and display in NTSC HD modes at all. If I set the console to PAL the Xbox shows the EVOX boot screen and then loads the dashboard fine (obviously only in the lowest res PAL mode) If I set the console to NTSC the Xbox shows the EVOX boot screen but then the dashboard won't show as it appears the TV is not receiving a HD signal. I am stuck, is there anything I can try? Thanks in advance.
so i have XBMC4gamers setup to run as an app. the trainers i downloaded from within the dash work fine but how do i add new trainers for games i have i downloaded soem new trainers but idk how to add them so that XBMC4gamers will see them
Sorry if this has been posted before but I needed to know so I thought I'd post here too. 256k Bank Bank 1: on on on on Bank 2: off on on on Bank 3: on off on on Bank 4: off off on on Bank 5: on on off on Bank 6: off on off on Bank 7: on off off on Bank 8: off off off on 512k Bank Bank 12: on on on off Bank 34: off on on off Bank 56: on off on off Bank 78: off off on off 1MB Bank Bank 1234: on on off offBank 5678: off on off off 2MB Bank Bank 12345678: off off off off
Board Life Status
Board startup date: April 23, 2017 12:45:48