Jump to content

Search the Community

Showing results for tags 'crack'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Off Topic
    • New Member Introductions
    • Rumble Pit
    • Suggestion Box.
  • General Xbox Discussion
    • General Xbox Discussion
  • Original Xbox Modding Forum
    • Hardware Mods
    • Modchips
    • TSOP Flashing
    • Softmods
    • Repair
  • Xbox Case Modding
    • Case Mods
    • Lighting & Electrical Mods
  • Tutorials
    • Official Tutorials
    • Tutorial Submission
  • Software
    • Bios
    • Dashboards
    • Installation Disks
    • Applications
    • Games
    • Emulators
    • Homebrew
  • Xbox Collecting
    • Xbox Collection Showcase
  • Rare and Uncommon
    • Rare and Uncommon Xbox Hardware
    • Rare and Uncommon Xbox Software
  • Vendors
    • N64 Freak's Products
    • Barnito's Products
  • Development
    • Rocky5's Projects
  • Online Play
    • Game Night
  • Classifieds
    • Wanted
    • For Sale
  • Moderator Section
    • Moderator Back Room

Product Groups

  • Vendor Forum
  • Membership Subscriptions

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


About Me

Found 2 results

  1. PV544

    Sid Meiers Pirates

    I ripped my copy of Sid Meiers Pirates to my xbox. It plays great but I can't add the _resource folder for poster and fanart for XBMC4Gamers. The rom has some security feature. Is there any way around this. It is the only game to do this. Or is there somewhere else I can put the poster and fanart so it will show up. Thanks
  2. the method using a pin and a soldering iron that floats around the net is unsustainable. i recently acquired a couple dead boards and one of them has samsung ram which my 1.2 had stolen from the bottom when i upgraded my 1.1 and ran out of new parts. so i said screw it im gonna put the 2 i need on this board. this is a way better homebrew than the pin. i made a small 'puller' out of a very thin piece of wire (the type thats inside of cheap cheap twist ties you get for the garbage bags. twisting the loop over top adds a subtle tension to keep hold of the chip. lots of flux applied to pins (not applied in this pic) each end is bent over and tucked under the row of pins, use a small enough gauge wire you arent jamming it in. heated slowly on low setting with a cheap heat gun (the econo brand heat gun) then one good blast at high once warmed up and it pulled right off. lots of movement of the gun and very delicate pressure when pulling. beautiful. they laid down on the other board with ease tack the corner on X & Yaxis, then line up pins and do another x & y. then just apply slight pressure with finger on chip and hit each pin with the iron. the unit fired right up. this solution originally came from removing a botched install.... removing i didnt want to accidentally scrape one of those small caps/resistors off. and i had already made a decision that hot air had to be the solution to removing these. handling the chip becomes most important once the solder goes molten. 20180318_183738.mp4

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.