Search the Community
Showing results for tags 'sideways'.
-
OK, I had a lot of trouble getting the AV port out of my v1.6 XBox. The solder pump I was using removed the traces on the underside of the board. Traces on the top are fine so I am able to tap the SPDIF and 5V. However, on the bottom, I tried using bodge wires soldered directly to the resistors going to pins 11, 12 and 13. My work so far has unfortunately been messy at best and I am getting flashing orange when starting the XBox so I am pretty sure it is my bodge work that is the issue. Does anyone know if there is a better way to short pins 11/12 and 13/14 elsewhere if my AV port through holes are toast? Reference picture of pins below... http://i.imgur.com/pyjq4y6.jpg BTW, the specific behavior I am seeing is I get a green light on the Xbox initially. The HD+ blue light blinks slowly (about every 3 seconds on 3 seconds off). After 10 or so seconds the Xbox flashes orange and needs to be unplugged to turn off. I did check the ribbon cable installation a couple of times. I checked for bridged connections. I also checked that I got continuity all the way from the ribbon far edge to the opposite side of the resistor that the trace was soldered to. So I believe the cable is soldered correctly (I'm sure, however, I could be proven wrong). I also tried checking continuity from by bodges to the other side of each resistor and had mixed results. I checked my soldering and it appears to be good. Not sure if maybe I fried the resistors if that is possible. Maybe I need to jump across the resistor (not sure if they do anything when pins 11/12 and 13/14 are bridged).
Board Life Status
Board startup date: April 23, 2017 12:45:48