Search the Community
Showing results for tags 'enough'.
-
I can see that the laser module has problems going up all the way as well. The drive tray catches on the spindle when trying to eject and then tries to close back up but the laser module and thus the gearing isn't cycling all the way and so the drive ends up popping back out and catching on the spindle again. I probably need to remove the drive tray to even start this, But where should I be checking to see why the laser module isn't dropping all the way to allow the drive tray to clear? Edit: The laser module IS dropping all the way. I can see that the tray is lowered all the way in this white piece of plastic that slides over when the tray starts to open. I can see that the black tab is all the way at the bottom of the slope in the mechanism. Why would the spindle still be sticking up too far? The tray looks straight... But the rear of the tray is still catching on the spindle. I cannot visually understand what is happening. Anyone seen this before? I may just cut away the plastic that's catching on the spindle and see if the laser module raises to the correct height when closed. The Xbox has never been opened before me so I have no idea what it possibly could have been that changed. I just tried to open the drive fully and I manuevered the rear of the tray past the module... and the laser just tried to read a disc with the tray all the way out... WTF? That spindle looks a bit high for resting position when fully closed.
Board Life Status
Board startup date: April 23, 2017 12:45:48