[Lo 1st Proper Post and Its a Biggy!]

lo sorry for delay

thanks for all the advice

k sort of sorted but now when plugging in unit will not power up full stop?

i will say that the board was in a crystal shell and i had an other unit which was already modded via tsop thingy

i swapped over shell between console but i am not sure if i mixed up the power supplies somehow

i will have play and see if i can swap the psu's over in the 2 units to get the above working

[Lo 1st Proper Post and Its a Biggy!]

plz note i did try do desolder/remove the header hence why soldering is a tad poor at the mo

[Lo 1st Proper Post and Its a Biggy!]

[Lo 1st Proper Post and Its a Biggy!]

[Lo 1st Proper Post and Its a Biggy!]

K thank you for the response. Will take a pic later and post up.

[Lo 1st Proper Post and Its a Biggy!]

k i have a 1.6 version xbox here

tested unit before trying and all was good

whilst fitting an aladdin chip and  doing the lpc rebuild do dar one of the pads on the mb has lifted

https://circuit-board.de/forum/index.php/Attachment/72198-Aladdin-XT-installation-Guide-pdf/

using the above guide its the cable from the top right point on the header to the contact/point (this is the oine thats lifted) between r7t3 and c7t3

i think the track is damaged

i have removed all wires installed elsewhere and re assembled and unit now showing FRAG

is it fubared? or is there a way to fix/sort?

thank you in advance

[Morning :P]

lo just signed up

have a couple of modded og xboxes here that could do with an update

no real idea how to go about this, but this seems to be the go to site for info

thanks in advance for any help or info