Jump to content
OGXbox.com

BigBoi73

Members
  • Posts

    7
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

BigBoi73's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. lo sorry for delay thanks for all the advice k sort of sorted but now when plugging in unit will not power up full stop? i will say that the board was in a crystal shell and i had an other unit which was already modded via tsop thingy i swapped over shell between console but i am not sure if i mixed up the power supplies somehow i will have play and see if i can swap the psu's over in the 2 units to get the above working
  2. plz note i did try do desolder/remove the header hence why soldering is a tad poor at the mo
  3. K thank you for the response. Will take a pic later and post up.
  4. k i have a 1.6 version xbox here tested unit before trying and all was good whilst fitting an aladdin chip and doing the lpc rebuild do dar one of the pads on the mb has lifted https://circuit-board.de/forum/index.php/Attachment/72198-Aladdin-XT-installation-Guide-pdf/ using the above guide its the cable from the top right point on the header to the contact/point (this is the oine thats lifted) between r7t3 and c7t3 i think the track is damaged i have removed all wires installed elsewhere and re assembled and unit now showing FRAG is it fubared? or is there a way to fix/sort? thank you in advance
  5. lo just signed up have a couple of modded og xboxes here that could do with an update no real idea how to go about this, but this seems to be the go to site for info thanks in advance for any help or info

Board Life Status


Board startup date: April 23, 2017 12:45:48
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.