obitus1990
-
Posts
7 -
Joined
-
Last visited
Content Type
Profiles
Forums
Calendar
Store
Posts posted by obitus1990
-
-
Any of these for sale currently?
-
Sorry for the double post, but, after looking inside a couple of the archives, some have .jed files in them, which is the CPLD code, I assume.
- 1
-
2 hours ago, neighbor said:
Don't they require the firmware for Lattice LC40XX chip?
You could always just program it with XBLASTOS, I suppose.
- 1
-
I located a broken/corroded trace along the front edge of the board. I ran a jumper wire from that last resistor prior to the drive transistors to a distant point on the board along that trace, and it now works properly. I found those hi-res scans especially helpful, as figuring out where some of those traces ran on an populated board was proving to be next to impossible.
-
KaosEngineer,
Do you have a schematic for a 1.0 board? I have a similar problem with my version 1.0. The green portion of the LED does not illuminate, only red. I can trace them back to check continuity if I have a proper schematic. THanks!
-
Questions:
1. Is it possible to remove the cover of the X3 switch without damaging the anything? I think my DIP switches are faulty, and, want to replace them.
2. Do you have part numbers/descriptions/names for the types of wire connectors used on the X3?
Board Life Status
Board startup date: April 23, 2017 12:45:48
Internal Hdmi Mod Diy Sets
in N64 Freak's Products
Posted
OK, I would like one if there is still one available. PM me.