jrme421
-
Posts
6 -
Joined
-
Last visited
Content Type
Profiles
Forums
Calendar
Store
Posts posted by jrme421
-
-
ther is continuit between resistor R3G4 and teh pic processor but no conitnuty between the fron tpanel and resistor R3G4
-
-
-
thanks kaosengineer. after tracing from the power pin of the front panel to the pic chip i couldnt get continuity. so i located the absence of continuite on the resistors R3G1 R3G2 R3G3 R3G4 however i checked the ohm and they do go through.
also i check the contunity right after the R3G3 resistor to the power pin on the pic chip and it went through.
do you think i need to change those 4 resistors? if so which one should i buy and where?
also its so weird all i did was changing capacitors on the other side of the board. why would it fry those resistors?
thanks a lot.
-
aftr replacing the clock capacitor the xbox wont turn on with the power button, it was turning on before
i cleaned the board with isopropol alcohol and check the conitnuity of the capacitors but everything seems to work, on a sidenote i replaced a few more capacitors that were included in the pack i bought on ebay but put back the originals after the xbox wont turn on, the only capacitor i kept replaced is the clock one, but i tried to turn on the xbox without the clock capacitor with the same problem
i just dont know where to look.
https://ibb.co/nQncPct
https://ibb.co/CPzG3Q8
https://ibb.co/zNnDMCY
https://ibb.co/jJ7xBR0
https://ibb.co/m5GKSM9
https://ibb.co/gFZDKZsalso the eject button is reponsive anf gives a green orange light its just power button that is unresponsive
i think my board is a 1.2
any ideas?
Board Life Status
Board startup date: April 23, 2017 12:45:48
xbox wont turn on after replacing clock capacitor
in Repair
Posted
thanks yes there is 10kohm and no conitnuity. so does it mean the problem isnt there?