jrme421
Members-
Posts
6 -
Joined
-
Last visited
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
jrme421's Achievements
-
thanks yes there is 10kohm and no conitnuity. so does it mean the problem isnt there?
-
ther is continuit between resistor R3G4 and teh pic processor but no conitnuty between the fron tpanel and resistor R3G4
-
i already checked those the trace are working, continuity is fine
-
i already checked those the trace are working, continuity is fine
-
thanks kaosengineer. after tracing from the power pin of the front panel to the pic chip i couldnt get continuity. so i located the absence of continuite on the resistors R3G1 R3G2 R3G3 R3G4 however i checked the ohm and they do go through. also i check the contunity right after the R3G3 resistor to the power pin on the pic chip and it went through. do you think i need to change those 4 resistors? if so which one should i buy and where? also its so weird all i did was changing capacitors on the other side of the board. why would it fry those resistors? thanks a lot.
-
jrme421 joined the community
-
aftr replacing the clock capacitor the xbox wont turn on with the power button, it was turning on before i cleaned the board with isopropol alcohol and check the conitnuity of the capacitors but everything seems to work, on a sidenote i replaced a few more capacitors that were included in the pack i bought on ebay but put back the originals after the xbox wont turn on, the only capacitor i kept replaced is the clock one, but i tried to turn on the xbox without the clock capacitor with the same problem i just dont know where to look. https://ibb.co/nQncPct https://ibb.co/CPzG3Q8 https://ibb.co/zNnDMCY https://ibb.co/jJ7xBR0 https://ibb.co/m5GKSM9 https://ibb.co/gFZDKZs also the eject button is reponsive anf gives a green orange light its just power button that is unresponsive i think my board is a 1.2 any ideas?
Board Life Status
Board startup date: April 23, 2017 12:45:48