[Wii2hdmi Original XBox Hdmi Diagram Wiring Schematic - Component To Hdmi]

Not sure if this was mentioned or not, but when I disable 480p on Xbmc the scanlines / interference is  gone. 

Assuming its running 480i?  

 

Doesn't look much worse to me for og xbox games and all 720p content looks great for my emulators.

 

[OpenXenium black screen when chip plugged in XB 1.6]

2 hours ago, SS_Dave said:

Soft modes and hard mods (Modchips/ Bios reflash) don't play nice with each other and you will get a black screen and it could also be tiring to load a bios file that's not suitable for the 1.6

If you power on the Xbox with the Eject button you should get the Open Xenium menu but it will be a washed out pic with lines though it if not then there is a problem with the Open Xenium fitting.

Also try booting the Xbox with the HDD disconnected.

 

You should be able to cold boot (Load the DVD in the DVD drive and power off then on ) a install disk like the OGXbox installer V1.5.3 disk and use the repair hard drive option to remove the soft mod.

You can down load that from here https://1fichier.com/dir/mX1kipIz

 

To fix the Open Xenium screen been looking faint/washed out you will need to down grade the Open Xenium OS.

 

Cheers

SS Dave

Soft modding is like masturbating, It gets the job done but it's nothing like the real thing.

 

I was actually able to get to the Xenium dash after I plugged the dvd drive in which to me is odd -  I was under the impression it should load the Xenium dash without.  

I am also wanting to install a new hard drive at the same time so I shouldn't need to run anything from here should I? 

 

Im new to this but my understanding from here is I can install the og xbox kernel, ftp over a bios and at that point run hexen for example to build my drive?   

 

Appreciate your advice!

[OpenXenium black screen when chip plugged in XB 1.6]

Hey guys, 

 

Wondering if someone might be able to help me with this.  Recently installed OpenXenium on my 1.6 with LPC board (pics attached).  Xbox turning on just fine but getting a black screen when video cables connected.  Tried both component and standard composite.  The Xbox led is green as per usual.  The chip led itself actually flashes so I know its getting power BUT after it flashes a few colors the chip LED turns off and I'm left with a black screen on the tv.   

 

When i remove my video cables from the xbox  and only have the power plugged into the Xbox the chip LED stays on, flashing every few seconds between red and yellow.  

 

Xbox boots fine to dash with chip unplugged.

 

The machine is soft modded.  Could that be causing an issue getting to the Xenium OS screen?   

 

Losing hope on this. Thoughts?